Pepperl+Fuchs LD28/LV28-F1/49/76a/82b/105 Thru-beam sensor

Pepperl+Fuchs LD28/LV28-F1/49/76a/82b/105
Item Number: LD28/LV28-F1/49/76a/82b/105
  • Universal series with highly versatile fields of use
  • Resistant against noise: reliable operation under all conditions
  • Highly visible LED as alignment aid in receiver optics
  • Emitter with test input
  • Version with red light
Price on Request
Total price: 0.00
Contact our experts
  • Overview
  • Datasheet
  • Alternative numbers
  • PDF
  • Comments
Function indicatorLED yellow:
1. LED lit constantly: signal > 2 x switching point (function reserve)
2. LED flashes: signal between 1 x switching point and 2 x switching point
3. LED off: signal < switching point
Diagnostic Coverage (DC)90 %
Angle of divergenceEmitter 1.2В°,
Receiver 5В°
Degree of protectionIP67
Threshold detection range40 m
Switching typelight/dark on, switchable
Diameter of the light spotapprox. 0.6 m at 30 m
Effective detection range0 ... 30 m
CCC approvalCCC approval / marking not required for products rated 36 V
Switching frequency1000 Hz
Ambient light limit50000 Lux
Storage temperature-40 ... 75 В°C (-40 ... 167 В°F)
Ripple10 %
Ambient temperature-40 ... 60 В°C (-40 ... 140 В°F)
Alignment aidLED red (in receiver lens)
illuminated constantly: beam is interrupted,
flashes: reaching switching point,
off: sufficient stability control
Mission Time (TM)20 a
Product standardEN 60947-5-2
Mass140 g (emitter and receiver)
MTTFd620 a
No-load supply currentEmitter: 50 mA
Receiver: 35 mA
Operating voltage10 ... 30 V DC
UL approvalcULus Listed , Class 2 power source
Housing depth54.3 mm
Test inputemitter deactivation at +UB (Imax. < 3 mA at 30 V DC)
Connection5-pin, M12 x 1 plastic connector
Operation indicatorLED green
Switching currentmax. 200 mA
Signal output1 NPN, 1 PNP synchronized-switching, short-circuit protected, reverse polarity protected , open collectors
Transmitter frequencyF1 = 25 kHz
Light typemodulated visible red light , 660 nm
Response time0.5 ms
Housing height88 mm
Switching voltagemax. 30 V DC
Housing width25.8 mm
Protection classII, rated voltage 250 V AC with pollution degree 1-2 according to IEC 60664-1
Pre-fault indication output1 PNP transistor, short-circuit protected, protected from reverse polarity, open collector, Umax = 30 V DC, Imax = 0.2 A
The output becomes inactive if the signal level has fallen below the function reserve for approx. 10 s (yellow and red LEDs flash).
If the light beam is interrupted four times during this period, the output immediately becomes inactive.
Control elementssensitivity adjustment (Adjustment to < 25% of the effective operating range) , Light-on/dark-on changeover switch
Light sourceLED


No comments yet

Write a comment

in international format without spaces
All fields are required