Pepperl+Fuchs FF MIO
FOUNDATION Fieldbus Modular I/O
- For 20 analog or 40 digital channels
- Sensors in Zone 0/Div. 1 (depending on module assembly)
- Installation in Zone 2, Div. 2 or safe area
- HART communication via service bus
- For FOUNDATION Fieldbus H1
- Configured via the process control system
- Non-volatile memory for configuration and parameter settings
- Quick communication set-up
- Permanently self-monitoring
- Outputs drive to safe state in case of failures
- Module can be exchanged under voltage
- Overview
- Comments
| Power consumption | max. 39 W , available output power for Zone 2 applications 5 W (5V), 20 W (12V), else 5 W (5V), 35 W (12V) |
| Connection | backplane LB9035A |
| Bus length | max. 1900 m (must not be exceeded by the sum of all trunk and spur lines) |
| Degree of protection | IP20 |
| Spur length | max. 120 m (depending on the number of field devices. Modular I/O station = 1 field device) |
| Statement of conformity | PF 08 CERT 1234 X |
| Auxiliary energy | 24 V DC Trunk load 10 mA according to FF standard. |
| Number of channels per station | max. 20 analog, max. 40 digital |
| Dimensions | 275 x 127 mm (10.8 x 5 inch) |
| Degree of protection | IEC 60529 |
| Number of stations per bus line | 1 or 2, depending on the required response times |
| Rated voltage | 24 V DC |
| Ambient temperature | -20 ... 60 В°C (-4 ... 140 В°F) |
| Addressing | via PCS (software) |
| LED indicator | Com unit LB8110*: LED green (power supply): on = operating, fast flash = cold start LED red (collective alarm): on = internal fault, flashing = no fieldbus LED yellow (operating mode): flashing = active Power supply LB9006C: LED green (power supply): off in case of loss of 24 V or 12 V or 5 V I/O modules (refer to the table with compatible modules for order codes): Power LED green: supply Diagnostic LED red: module fault, red flashing: communication error Status LED red: line fault Status LED yellow: signal (Live Zero status) |
| Station connection | directly at the trunk or via spur protector |
Comments
No comments yet