Pepperl+Fuchs LD28/LV28-F2/47/76a/82b/105
Thru-beam sensor
- Ultra bright LEDs for power on, weak signal indication and switching state
- Highly visible LED as alignment aid in receiver optics
- Emitter deactivation
- Various transmitter frequencies
- Not sensitive to ambient light, even with switched energy saving lamps
- Waterproof, degree of protection IP67
- Protection class II
- Overview
- Comments
| Diameter of the light spot | approx. 0.6 m at 30 m |
| Protection class | II, rated voltage 250 V AC with pollution degree 1-2 according to IEC 60664-1 |
| Response time | 0.5 ms |
| Signal output | 2 PNP, complementary, short-circuit protected, reverse polarity protected , open collectors |
| Pre-fault indication output | 1 PNP transistor, short-circuit protected, protected from reverse polarity, open collector, Umax = 30 V DC, Imax = 0.2 A The output becomes inactive if the signal level has fallen below the function reserve for approx. 10 s (yellow and red LEDs flash). If the light beam is interrupted four times during this period, the output immediately becomes inactive. |
| Light source | LED |
| UL approval | cULus |
| Angle of divergence | Emitter 1.2В°, Receiver 5В° |
| Transmitter frequency | F2 = 30 kHz |
| Housing height | 88 mm |
| MTTFd | 620 a |
| Alignment aid | LED red (in receiver lens) illuminated constantly: beam is interrupted, flashes: reaching switching point, off: sufficient stability control |
| Ripple | 10 % |
| Mass | 140 g (emitter and receiver) |
| Product standard | EN 60947-5-2 |
| CCC approval | CCC approval / marking not required for products rated 36 V |
| Switching voltage | max. 30 V DC |
| Ambient temperature | -40 ... 60 В°C (-40 ... 140 В°F) |
| Storage temperature | -40 ... 75 В°C (-40 ... 167 В°F) |
| Receiver | LV28-F2/47/82b/105 |
| Operating voltage | 10 ... 30 V DC |
| Threshold detection range | 40 m |
| Function indicator | LED yellow: 1. LED lit constantly: signal > 2 x switching point (function reserve) 2. LED flashes: signal between 1 x switching point and 2 x switching point 3. LED off: signal < switching point |
| Switching frequency | 1000 Hz |
| Mission Time (TM) | 20 a |
| Housing width | 25.8 mm |
| Degree of protection | IP67 |
| Test input | emitter deactivation at +UB (Imax. < 3 mA at 30 V DC) |
| No-load supply current | Emitter: 50 mA Receiver: 35 mA |
| Operation indicator | LED green |
| Housing depth | 54.3 mm |
| Connection | 5-pin, M12 x 1 plastic connector |
| Diagnostic Coverage (DC) | 90 % |
| Ambient light limit | 50000 Lux |
| Switching current | max. 200 mA |
| Effective detection range | 0 ... 30 m |
| Switching type | light/dark on, switchable |
| Control elements | sensitivity adjustment (Adjustment to < 25% of the effective operating range) , Light-on/dark-on changeover switch |
| Light type | modulated visible red light , 660 nm |
| Emitter | LD28-F2/76a/105 |
Comments
No comments yet