Pepperl+Fuchs NRB15-30GS50-E2-IO-V1
Inductive sensor
- 15 mm flush
- Reduction factor = 1
- Magnetic field resistant
- IO-link interface for service and process data
- Switch point mode or window mode can be set
- Switching function, stability alarm and pulse extension can be set
- Overview
- Comments
| CCC approval | CCC approval / marking not required for products rated 36 V |
| Assured operating distance | 0 ... 12.15 mm |
| Alternating magnetic field | 200 mT |
| Protection class | II |
| No-load supply current | 15 mA |
| Housing material | Stainless steel 1.4305 / AISI 303 |
| Output type | 3-wire |
| Min. cycle time | 2.3 ms |
| Rated operating distance | 15 mm (factory setting) |
| SIO mode support | yes |
| Scope of delivery | 2 self locking nuts in scope of delivery |
| Degree of protection | IP67 |
| Default setting | operating mode = switch point mode with stability alarm switching function = Normally open (NO) switching distance = 15 mm |
| Ambient temperature | -25 ... 70 В°C (-13 ... 158 В°F) |
| Device ID | 0x201003 (2101251) |
| UL approval | cULus Listed, General Purpose Class 2 power source |
| Output type | PNP |
| Reduction factor r304 | 1 |
| Process data witdh | Process data input (control system side): 2 Bit Process data output (control system side): none |
| Compatible master port type | A |
| MTTFd | 362 a |
| Off-state current | 0 ... 0.5 mA typ. 60 andmicro;A at 25 В°C |
| Connection type | Connector plug M12 x 1 , 4-pin |
| Interface type | IO-Link ( via C/Q = pin 4 ) |
| Near operating distance | 10 mm (can be activated by software) |
| Reverse polarity protection | reverse polarity protected |
| Status indicator | Multihole-LED, yellow |
| Hysteresis | typ. 3 % |
| Short-circuit protection | pulsing |
| Constant magnetic field | 200 mT |
| Mission Time (TM) | 20 a |
| Time delay before availability | max. 150 ms |
| Mass | 153 g |
| Output polarity | DC |
| Transfer rate | COM 2 (38.4 kBaud) |
| IO-Link Revision | 1.1 |
| Operating current | 0 ... 200 mA |
| Sensing face | PBT |
| Switching frequency | 0 ... 600 Hz (switch point mode) 0 ... 25 Hz (window mode, switch point mode with stability alarm) |
| Operating voltage | 10 ... 30 V DC |
| Reduction factor rAl | 1 |
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Switching function | Normally open/closed (NO/NC) programmable |
| Diagnostic Coverage (DC) | 0 % |
| Installation | flush |
| Reduction factor rCu | 1 |
| Reduction factor rSt37 | 1 |
| Voltage drop | 0.5 V |
Comments
No comments yet