Pepperl+Fuchs NSB2-12GH45-2E2-V1-M1-S2D2 Inductive sensor
Item Number: NSB2-12GH45-2E2-V1-M1-S2D2
- No unusable area
- 2 mm flush
- Use of standard metallic actuating surfaces
- Applications up to Cat. 2, PLd/SIL 2 possible (can be used redundantly up to Cat. 3, PLe/SIL 3)
- LED for switching state and fault indication
- Safety outputs OSSD
- TГњV certified
- E1-Type approval
- Extended temperature range
-40 ... +85 В°C
- Overview
- Datasheet
- Alternative numbers
- Comments
| Hysteresis | typ. 5% |
| UL approval | cULus Listed, General Purpose, Class 2 Power Source |
| Rated operating distance | 2 mm |
| Reduction factor rBrass | 0.6 |
| Actuating element | Reference target according EN IEC 60947-5-2 (FE360 - ST37K) 12 mm x 12 mm x 1 mm |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Reduction factor rAl | 0.6 |
| Output polarity | DC |
| MTTFd | > 7500 a |
| Error indicator | LED, red |
| Housing material | stainless steel 1.4404 / AISI 316L |
| Ambient temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Reduction factor r304 | 0.9 |
| Rated insulation voltage | 30 V |
| Reduction factor rCu | 0.45 |
| Altitude | ≤ 2000 m above MSL |
| Installation | flush |
| Assured release distance of a PDDB | 3 mm |
| Safety Integrity Level (SIL) | SIL 2 |
| Mission Time (TM) | 20 a |
| Off-state current | 0 ... 0.5 mA |
| Diagnostic Coverage (DC) | min. 60 % |
| Performance level (PL) | PL d |
| Category | Cat. 2 |
| No-load supply current | ≤ 15 mA |
| Operating current | 1 ... 30 mA per output |
| Time delay before availability | ≤ 300 ms |
| Assured operating distance | 0 ... 1.62 mm |
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Output type | 4-wire |
| Sensing face | PBT |
| Reverse polarity protection | reverse polarity protected |
| Operating voltage | 18 ... 30 V |
| Scope of delivery | Supplied with 2 nuts |
| Switching frequency | 0 ... 30 Hz |
| Voltage drop | ≤ 3 V |
| Rated operating voltage | 24 V |
| Short-circuit protection | pulsing |
| Switching state indicator | LED, yellow |
| E1 Type approval | 10R-04 |
| Mass | 18 g |
| Switching function | 2 x normally open (NO) |
| Output type | PNP |
| Degree of protection | IP68 / IP69 |
| Connection type | Connector plug M12 x 1 , 4-pin |
| Overload resistance | yes |
Comments
No comments yet