Pepperl+Fuchs UC250-F77-IU-IO-5M Ultrasonic sensor
Item Number: UC250-F77-IU-IO-5M
- IO-Link interface for parameterization
- Programmable via DTM with PACTWARE
- Selectable sound lobe width
- Synchronization options
- Temperature compensation
- Analog output
- Overview
- Datasheet
- Alternative numbers
- Comments
Deviation of the characteristic curve≤ В± 1 % of full-scale valuefrom 10 minutes after switching on the sensor ; 0,17 %/K (without temperature compensation)
| Core cross-section | 4 x 0.19 mm2 | ||||||||||||
| UL approval | cULus Listed, Class 2 Power Source | ||||||||||||
| No-load supply current | ≤ 50 mA | ||||||||||||
| Non-volatile memory | EEPROM | ||||||||||||
| Beam width | wide | ||||||||||||
| Connection type | cable PUR , 5 m | ||||||||||||
| Time delay before availability | ≤ 300 ms | ||||||||||||
| Degree of protection | IP67 | ||||||||||||
| Load impedance | current output: ≤ 500 Ohm voltage output: ≥ 1000 Ohm | ||||||||||||
| Installation position | any position | ||||||||||||
| LED yellow | solid: object in evaluation range flashing: programming of the limits, object detected | ||||||||||||
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) | ||||||||||||
| Adjustment range | 25 ... 250 mm | ||||||||||||
| Input/output type | 1 synchronization connection, bidirectional | ||||||||||||
| LED red | solid: fault flashing: programming limits, object not detected | ||||||||||||
| Power consumption | ≤ 500 mW | ||||||||||||
| Resolution | current output: evaluation range [mm]/3200 but ≥ 0.35 mm voltage output: evaluation range [mm]/4000 but ≥ 0.35 mm | ||||||||||||
| Temperature influence | ≤ В± 0.75 % of the end value (with temperature compensation) | Tightening torque, fastening screws | max. 0.2 Nm | Output | near limit: 25 mm far limit: 250 mm Output mode: rising ramp output type: 4 ... 20 mA | Transducer frequency | approx. 400 kHz | Dead band | 0 ... 20 mm | LED green | solid: power on flashing: standby mode or IO-Link communication | Response delay | minimum : 8 ms factory setting: 29 ms |
| Interface type | IO-Link (available after activation via programming button until next reset) | ||||||||||||
| CCC approval | CCC approval / marking not required for products rated ≤36 V | ||||||||||||
| Sensing range | 20 ... 250 mm | ||||||||||||
| Repeat accuracy | ≤ В± 0.1 % of full-scale value | ||||||||||||
| Operating voltage | 18 ... 30 V DC , ripple 10 %SS | ||||||||||||
| Sensor cycle time | ≥ 8 ms (factory setting) ; programmable to 60 s | ||||||||||||
| Output type | 1 analog output 0 (4) ... 20 mA or 1 analog output 0 ... 10 V | ||||||||||||
| Standard target plate | 10 mm x 10 mm | ||||||||||||
| Mass | 114 g | ||||||||||||
| Ambient temperature | current output -25 ... 60 В°C (-13 ... 140 В°F) voltage output -25 ... 70 В°C (-13 ... 158 В°F) | ||||||||||||
| Write cycles | 300000 |
Comments
No comments yet