Pepperl+Fuchs UC250-F77-IU-IO-V31

Ultrasonic sensor

from 10 minutes after switching on the sensor ; 0,17 %/K (without temperature compensation)

Deviation of the characteristic curve	В± 1 % of full-scale value
Sensor cycle time	8 ms (factory setting) ; programmable to 60 s
LED yellow	solid: object in evaluation range flashing: programming of the limits, object detected
Repeat accuracy	В± 0.1 % of full-scale value
Interface type	IO-Link (after individual activation via programming button)
Power consumption	500 mW
Operating voltage	18 ... 30 V DC , ripple 10 %SS
Output type	1 analog output 0 (4) ... 20 mA or 1 analog output 0 ... 10 V
CCC approval	CCC approval / marking not required for products rated 36 V
Transducer frequency	approx. 400 kHz
LED green	solid: Power on flashing: Standby mode or IO-Link communication
No-load supply current	50 mA
Resolution	current output: evaluation range [mm]/3200 but 0.35 mm voltage output: evaluation range [mm]/4000 but 0.35 mm
Sensing range	20 ... 250 mm
UL approval	cULus Listed, Class 2 Power Source
Standard target plate	10 mm x 10 mm
Input/output type	1 synchronization connection, bidirectional
Storage temperature	-40 ... 85 В°C (-40 ... 185 В°F)
Adjustment range	25 ... 250 mm
Response delay	minimum : 8 ms factory setting: 29 ms
Dead band	0 ... 20 mm
Tightening torque, fastening screws	max. 0.2 Nm
Load impedance	current output: 500 Ohm voltage output: 1000 Ohm
Temperature influence	В± 0.75 % of the end value (with temperature compensation)
Degree of protection	IP67
Mass	9 g
LED red	solid: fault Flashing: programming limits, object not detected
Connection type	Connector plug M8 x 1 , 4-pin
Ambient temperature	current output -25 ... 60 В°C (-13 ... 140 В°F) voltage output -25 ... 70 В°C (-13 ... 158 В°F)