Pepperl+Fuchs UC6000-30GM-IUEP-IO-V15 Ultrasonic sensor
Item Number: UC6000-30GM-IUEP-IO-V15
- IO-link interface for service and process data
- Programmable via DTM with PACTWARE
- Switch output and analog output
- Selectable sound lobe width
- Synchronization options
- Temperature compensation
- Overview
- Datasheet
- Alternative numbers
- Comments
| LED red | solid red: Error red, flashing: program function, object not detected |
| Temperature influence | 1.5 % from full-scale value (with temperature compensation) 0.2 %/K (without temperature compensation) |
| Repeat accuracy | 0.1 % of full-scale value |
| No-load supply current | 60 mA |
| Range hysteresis | 1 % of the adjusted operating range (default settings), programmable |
| LED green | solid: Power on flashing: Standby mode or IO link communication |
| Switching frequency | 1.5 Hz |
| Load impedance | current output: 300 Ohm voltage output: 1000 Ohm |
| Rated operating current | 200 mA , short-circuit/overload protected |
| Protocol | IO-Link V1.0 |
| Standard target plate | 100 mm x 100 mm |
| Process data witdh | 16 bit |
| Response delay | minimum : 140 ms factory setting: 280 ms |
| Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected Current output 4 mA ... 20 mA or voltage output 0 V ... 10 V configurable |
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Deviation of the characteristic curve | 0.2 % of full-scale value |
| LED yellow 2 | solid: Object in evaluation range flashing: Learning function, object detected |
| UL approval | cULus Listed, General Purpose |
| Adjustment range | 400 ... 6000 mm |
| SIO mode support | yes |
| Resolution | current output: evaluation range [mm]/3200 but 0.35 mm voltage output: evaluation range [mm]/4000 but 0.35 mm |
| Dead band | 0 ... 350 mm |
| Sensing range | 350 ... 6000 mm |
| Interface type | IO-Link |
| Input/output type | 1 synchronization connection, bidirectional |
| Connection type | Connector plug M12 x 1 , 5-pin |
| CSA approval | cCSAus Listed, General Purpose |
| Transducer frequency | approx. 65 kHz |
| CCC approval | CCC approval / marking not required for products rated 36 V |
| Transfer rate | Acyclical: typical 44 Bit/s |
| Ambient temperature | -25 ... 70 В°C (-13 ... 158 В°F) |
| LED yellow 1 | solid: Object in evaluation range flashing: Learning function, object detected |
| Mass | 165 g |
| Cycle time | min. 72 ms |
| Degree of protection | IP67 |
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS 15 ... 30 V voltage output |
| Power consumption | 1 W |
| Voltage drop | 2.5 V |
Comments
No comments yet