Pepperl+Fuchs UC800-F77S-EP-IO-V31
Ultrasonic sensor
- IO-link interface for service and process data
- Programmable via DTM with PACTWARE
- Continuous distance value via IO-Link process data
- Selectable sound lobe width
- Synchronization options
- Temperature compensation
- Push-pull output
Item Number:
UC800-F77S-EP-IO-V31
The price is not final. Please check with the manager!
Contact our experts
- Overview
- Comments
| Beam width | wide |
| Device ID | 0x300302 (3146498) |
| No-load supply current | 40 mA |
| SIO mode support | yes |
| Compatible master port type | A |
| Degree of protection | IP67 |
| Write cycles | 300000 |
| IO-Link Revision | 1.1 |
| Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected |
| CCC approval | CCC approval / marking not required for products rated 36 V |
| UL approval | cULus Listed, Class 2 Power Source |
| LED red | solid: error flashing: switch point programming, object not detected |
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Installation position | any position |
| Standard target plate | 100 mm x 100 mm |
| Power consumption | 400 mW |
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS |
| Time delay before availability | 300 ms |
| Input/output type | 1 synchronization connection, bidirectional |
| LED yellow | solid: object in evaluation range flashing: switch point programming, object detected |
| Device profile | Smart Sensor |
| Sensing range | 60 ... 800 mm |
| Adjustment range | 70 ... 800 mm |
| Transducer frequency | approx. 255 kHz |
| Repeat accuracy | В± 0.1 % of full-scale value |
| Response delay | minimum : 13 ms factory setting: 49 ms |
| Tightening torque, fastening screws | with M3 nuts max. 0.2 Nm with M18 nuts max. 1 Nm |
| Ambient temperature | -25 ... 70 В°C (-13 ... 158 В°F) When fixing with one M18 nut, the temperature range begins with 0 В°C (32 В°F). |
| Connection type | Connector plug M8 x 1 , 4-pin |
| Min. cycle time | 2.3 ms |
| Switching frequency | factory setting: 12 Hz programmable max. 27 Hz |
| Temperature influence | В± 0.75 % of the end value (with temperature compensation) |
| Range hysteresis | 1 % of the adjusted operating range (default settings), programmable , min. 1 mm |
| Sensor cycle time | 13 ms (factory setting) ; programmable to 60 s |
| Process data witdh | 16 bit |
| Dead band | 0 ... 60 mm |
| Interface type | IO-Link (via C/Q = Pin 4) |
| Rated operating current | 100 mA , short-circuit/overload protected |
| Non-volatile memory | EEPROM |
| LED green | solid: Power on flashing: Standby mode or IO-Link communication |
| Output | near switch point: 70 mm far switch point: 800 mm Output mode: Window mode Output logic: normally open |
| Mass | 13 g |
| Voltage drop | 2.5 V |
| Transfer rate | COM 2 (38.4 kBaud) |
Comments
No comments yet