Pepperl+Fuchs UCC2500-50GK-B26-8MOL Ultrasonic sensor
Item Number: UCC2500-50GK-B26-8MOL
- Thread M50
- PTFE coated transducer
- Power save mode
- PWM output
- Physical LIN interface
- Serial Interfaces
- Temperature compensation
- Overview
- Datasheet
- Alternative numbers
- Comments
| Sensing range | 150 ... 2500 mm |
| Resolution | 10 mm (corresponding to 1 LSB) |
| Ambient temperature | -25 ... 70 В°C (-13 ... 158 В°F) |
| Standard target plate | 100 mm x 100 mm |
| Output type | PWM output (PNP) , not short-circuit protected |
| Signal level | low: 0 ... 0.8 V |
| No-load supply current | ≤ 60 mA at 3.3 V DC ≤ 20 mA at 12 V DC |
| Time delay before availability | ≤ 70 ms |
| Transducer frequency | approx. 120 kHz |
| Input type | Standby active |
| Resolution | 10 mm (corresponding to 1 LSB) |
| Beam width | wide |
| Degree of protection | IP66 / IP67 ( connector excluded ) |
| Interface type | UART 3.3V |
| Transfer rate | 19.2 kBit/s (8N1) |
| Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
| Scope of delivery | 2 nuts plastic |
| Transfer rate | 19.2 kBit/s (8N1) |
| Temperature influence | 3 % of full-scale value over the entire temperature range |
| Quiescent current indication | < 3 ВµA during standby mode at UART- and PWM operation |
| Output rated operating current | max. 10 mA |
| Cycle time | 55 ms |
| Connection type | cable L = 276 mm В± 20 mm with Molex connector 70107-0007, 8-pin |
| Interface type | Physical LIN interface |
| Output | PWM output (PNP) Temperature compensation Address setting 7 |
| Power consumption | ≤ 250 mW in the measurement operating mode |
| Resolution | pulse length 10 Вµs /cm |
| Mass | 100 g |
| Operating voltage | for UART and PWM operation: UUART/PWM = 2.5 ... 5 V DC, typical 3.3 V for LIN operation: ULIN = 8 ... 18 V DC, typical 12 V |
| Dead band | 0 ... 150 mm |
| Cycle time | 55 ms |
Comments
No comments yet