Pepperl+Fuchs VBG-ENX-K20-DMD-EV
AS-Interface gateway
- Connection to Ethernet Modbus TCP/IP
- 2 AS-Interface networks
- Easy commissioning and fault diagnosis via LEDs and graphic display
- Dublicate addressing detection
- Integrated data decoupling
- Integrated switch allows line topology
- Integrated webserver
- Earth fault detection
- AS-Interface noise detection
- Ethernet diagnostic interface
- DLR technology supports ring topology
Item Number:
VBG-ENX-K20-DMD-EV
The price is not final. Please check with the manager!
Contact our experts
- Overview
- Comments
| EMC monitoring | integrated |
| AS-Interface | spring terminals, removable |
| AS-Interface | EN 62026-2:2013 |
| Insulation voltage | 500 V |
| Mass | 500 g |
| Degree of protection | IP20 |
| Degree of protection | EN 60529:2000 |
| Rated operating current | 250 mA PELV |
| Switch SET | Selection and setting of a slave address |
| Interface type | RS 232, serial Diagnostic Interface |
| Ethernet | RJ-45 |
| Storage temperature | -25 ... 85 В°C (-13 ... 185 В°F) |
| OK button | Mode selection traditional-graphical/confirmation |
| Interface type | Chip card slot |
| UL File Number | E223772 only from low voltage, limited energy source (SELV or PELV) or listed Class 2 source |
| Rated operating voltage | from AS-Interface 30 V DC |
| Interface type | 2 x RJ-45 |
| Earth fault detection | integrated |
| Transfer rate | 10 MBit/s / 100 MBit/s , Automatic baud rate detection |
| LED CONFIG ERR | configuration error; LED red |
| LED PRG ENABLE | autom. programming; LED green |
| Display | Illuminated graphical LC display for addressing and error messages |
| PLC-Functionality | activateable |
| Transfer rate | 19,2 kBit/s |
| Construction type | Low profile housing , Stainless steel |
| Duplicate address detection | from AS-Interface slaves |
| Button MODE | Mode selection PRJ-operation/save configuration/cursor |
| LED U AS-i | AS-Interface voltage; LED green |
| Protocol | EtherNet/IP + MODBUS TCP/IP acc. to IEEE 802.3 supports device level ring protocol DLR |
| Button | 4 |
| LED SER ACTIVE | ethernet active; LED green |
| AS-Interface specification | V3.0 |
| Electromagnetic compatibility | EN 61000-6-2:2005, EN 61000-6-4:2007 |
| UL approval | An isolated source with a secondary open circuit voltage of 30 VDC with a 3 A maximum over current protection. Over current protection is not required when a Class 2 source is employed. UL mark does not provide UL certification for any functional safety rating or aspects of the device. |
| LED PRJ MODE | projecting mode active; LED yellow |
| LED AS-i ACTIVE | AS-Interface operation normal; LED green |
| Ambient temperature | 0 ... 55 В°C (32 ... 131 В°F) |
| Diagnostics function | Extended function via display |
| LED POWER | voltage ON; LED green |
| ESC button | Mode selection traditional-graphical/cancel |
Comments
No comments yet