Pepperl+Fuchs UC250-F77-IU-IO-2M Ultrasonic sensor


Item Number: UC250-F77-IU-IO-2M
- IO-Link interface for parameterization
- Programmable via DTM with PACTWARE
- Selectable sound lobe width
- Synchronization options
- Temperature compensation
- Analog output
- Overview
- Datasheet
- Alternative numbers
- Comments
LED green | solid: power on flashing: standby mode or IO-Link communication |
Write cycles | 300000 |
Adjustment range | 25 ... 250 mm |
Standard target plate | 10 mm x 10 mm |
Installation position | any position |
CCC approval | CCC approval / marking not required for products rated ≤36 V |
Repeat accuracy | ≤ В± 0.1 % of full-scale value |
Transducer frequency | approx. 400 kHz |
Tightening torque, fastening screws | max. 0.2 Nm |
No-load supply current | ≤ 50 mA |
Dead band | 0 ... 20 mm |
Temperature influence | ≤ В± 0.75 % of the end value (with temperature compensation) |
Load impedance | current output: ≤ 500 Ohm voltage output: ≥ 1000 Ohm |
Core cross-section | 4 x 0.19 mm2 |
Response delay | minimum : 8 ms factory setting: 29 ms |
LED red | solid: fault flashing: programming limits, object not detected |
Sensing range | 20 ... 250 mm |
Non-volatile memory | EEPROM |
Mass | 51 g |
Sensor cycle time | ≥ 8 ms (factory setting) ; programmable to 60 s |
Output | near limit: 25 mm far limit: 250 mm Output mode: rising ramp output type: 4 ... 20 mA |
Power consumption | ≤ 500 mW |
Connection type | cable PUR , 2 m |
Storage temperature | -40 ... 85 В°C (-40 ... 185 В°F) |
Operating voltage | 18 ... 30 V DC , ripple 10 %SS |
Degree of protection | IP67 |
Resolution | current output: evaluation range [mm]/3200 but ≥ 0.35 mm voltage output: evaluation range [mm]/4000 but ≥ 0.35 mm |
Output type | 1 analog output 0 (4) ... 20 mA or 1 analog output 0 ... 10 V |
LED yellow | solid: object in evaluation range flashing: programming of the limits, object detected |
Ambient temperature | current output -25 ... 60 В°C (-13 ... 140 В°F) voltage output -25 ... 70 В°C (-13 ... 158 В°F) |
Input/output type | 1 synchronization connection, bidirectional |
UL approval | cULus Listed, Class 2 Power Source |
Beam width | wide |
Interface type | IO-Link (available after activation via programming button until next reset) |
Deviation of the characteristic curve | ≤ В± 1 % of full-scale value |
Time delay before availability | ≤ 300 ms |
People also buy
Comments
No comments yet