Pepperl+Fuchs K-System
- Alternative power supply
- Nominal current 4 A
- Simple installation
- Standard length 50 cm, can be shortened to any length in 4 cm steps
- Terminating insulation by end cap, included in the delivery package
- With 2 leads for power supply, 2 leads for bus connections and 1 lead for centralised error messages or HART signal transfer (with RPI-system)
- Adapter for mounting a K-device to S1000 termination board
- Snap-on
- Additional cable sets depending on K-device
stc4 d
- Operating temperature: -20 to 60 °C.
- Humidity: up to 95% at 40 °C.
- Mounting: on a DIN rail or on a wall
- 35 mm DIN mounting rail with 3-conductor insert
- Provides DC supply voltage to all equipped K-System modules
- Standard length 2 m (6 foot), simple to customize to application space
- Eliminates daisy-chains
- 35 mm DIN mounting rail with 3-conductor insert
- Provides DC supply voltage to all equipped K-System modules
- Standard length 1.6 m (5 foot), simple to customize to application space
- Eliminates daisy-chains
- 35 mm DIN mounting rail with 3-conductor insert
- Provides DC supply voltage to all equipped K-System modules
- Standard length 0.8 m (2.6 ft), simple to customize to application space
- Eliminates daisy-chains
- 35 mm DIN mounting rail with 5-conductor insert
- Provides DC supply voltage and the bus connection to all equipped K-System modules
- Standard length 2 m (6 foot), simple to customize to application space
- Eliminates daisy-chains
- 35 mm DIN mounting rail with 5-conductor insert
- Provides DC supply voltage and the bus connection to all equipped K-System modules
- Standard length 0.8 m (2.6 ft), simple to customize to application space
- Eliminates daisy-chains
- Termination of DIN mounting rail
- Suitable for Power Rail UPR-**-*
- Suitable for profile rail K-DUCT
- 3-conductor insert in 35 mm DIN mounting rail
- Suitable for 35 mm DIN mounting rail UPR-MR
- Suitable for profile rail K-DUCT
- Standard length 2 m (6 foot), simple to customize to application space
- 1-channel
- Dry contact input
- For line fault detection (LFD)