Baumer Encoders

Through Hollow Shaft Incremental Encoder with Stator Coupling

• Sensor method: Optical
• Dimensions (flange): ø58 mm

Through Hollow Shaft Incremental Encoder with Stator Coupling

art. 11042579

Baumer tachogenerator with high response speed, open circuit voltage 20...60mV per rpm and connector output.

shaft 16 mm

The operation of the sensor is based on the optical incremental principle.

discrete shaft angle sensor

discrete shaft angle sensor

The operation of the sensor is based on the optical incremental principle.

Blind hollow shaft

Encoder with blind hollow shaft

Incremental encoder with blind hollow shaf

Incremental encoder with blind hollow shaft

Incremental encoders with through hollow shaft

Incremental encoders with blind hollow shaft

Incremental magnetic encoder

Linear bearingless incremental encoders

Incremental magnetic linear encoder

Bearingless incremental encoders

Incremental encoders without bearings

Incremental tachogenerator

Incremental encoders

• Through hollow shaft ø70 mm
• Optical sensing method
• Output stage HTL or TTL
• Output stage TTL with regulator UB 9...26 VDC

amg 11

• Multiturn SSI / Profibus / CANopen® / DeviceNet / PROFINET
• Optical sensing method
• Singleturn 13 bit, multiturn 12 bit / 16 bit
• EURO flange B10 / solid shaft ø11 mm
• Multiturn sensing with microGen technologie, without gear or battery
• Available with redundant absolute signals

AMG 11 + FSL

• Code: Gray (SSI Version)
• Code Sequence: CW by default
• Inputs: SSI clock (SSI version)

amg 71

• Measurement method: Optical
• Code: Gray
• Code sequence: CW
• Inputs: SSI clock

AMG 73 S W29 S2048

• Interface: SSI (Synchronous Serial Interface)
• Output signal: Parallel, SSI
• Maximum refresh rate: 10 kHz
• Moment of inertia: 6.2 x 10^-6 kg·m²

AMG 81

• Optical sensing method
• Multiturn/SSI/Profibus/CANopen®
• Singleturn 13 bit, multiturn 12 bit / 16 bit
• EURO flange B10 / solid shaft ø11 mm

ATD 07S A 4

• Measurement method: Magnetic
• Resolution: 12 bits (single revolution)
• Blind hollow shaft diameter: 4 mm
• Output signals: Gray code

ATD 2A B14 Y 1

• Solid shaft ø6 mm with synchro flange
• Analog signals
• 14 bit singleturn
• Factory-set adjustable angle (0° - 360°)
• Centering alignment ø50 mm, mounting screw hole circle ø68 mm

ATD 2B A 4 Y26 absolute encoder

ATD 2B B14 Y22 absolute encoder

ATD 2S A 4 Y 7 

• Through hollow shaft ø10 to ø14 mm
• Encoder multiturn / SSI
• Optical sensing singleturn, magnetical sensing multiturn
• Resolution: max. multiturn 24 bit
• Self-diagnostic